Lenze EVS9332xS - Manual (Page 110)

Function library
Function blocks
3.2.23 Control of the drive controller (DCTRL)
3−58
l
EDSVS9332S−EXT EN 2.0
Signal Source Note
Name Type DIS DIS format CFG List Lenze
DCTRL−CINH1 d C0878/1 bin C0870/1 2 1000 HIGH = Inhibit controller
DCTRL−CINH2 d C0878/2 bin C0870/2 2 1000 HIGH = Inhibit controller
DCTRL−TRIP−SET d C0878/3 bin C0871 2 54 HIGH = Fault signal EEr
DCTRL−TRIP−RESET d C0878/4 bin C0876 2 55 LOW−HIGH signal = TRIP reset
DCTRL−PAR*1 d C0884/1 bin C0880/1 2 1000 Selecting a parameter set
DCTRL−PAR*2 d C0884/2 bin C0880/2 2 1000 Selecting a parameter set
DCTRL−PAR−LOAD d C0884/3 bin C0881 2 1000 LOW−HIGH edge = Loading a parameter set
DCTRL−QSP d − − − − − HIGH = Drive performs quick stop
DCTRL−RDY d − − − − − HIGH = Ready for operation
DCTRL−CINH d − − − − − HIGH = Controller reset
DCTRL−IMP d − − − − − HIGH = High−resistance power output
stages
DCTRL−TRIP d − − − − − HIGH = Active fault
DCTRL−WARN d − − − − − HIGH = Active warning
DCTRL−MESS d − − − − − HIGH = Active message
DCTRL−FAIL d − − − − − −
DCTRL−CW/CCW d − − − − − LOW = CW rotation, HIGH = CCW rotation
DCTRL−NACT=0 d − − − − − HIGH = Motor speed < C0019
DCTRL−STAT*1 d − − − − − General status (binary coded)
DCTRL−STAT*2 d − − − − − General status (binary coded)
DCTRL−STAT*4 d − − − − − General status (binary coded)
DCTRL−STAT*8 d − − − − − General status (binary coded)
DCTRL−INIT d − − − − − −
DCTRL−PARBUSY d − − − − HIGH = Parameter set changeover is active
DCTRL−PAR*1−O d − − − − − Parameter set X is active (binary coded)
DCTRL−PAR*2−0 d − − − − − Parameter set X is active (binary coded)
Function
l Quick stop (QSP)
l Operation inhibited (DISABLE)
l Controller inhibit (CINH)
l TRIP−set
l TRIP−RESET
l Change of parameter set (PAR)
l Controller state
3.2.23.1 Quick stop (QSP)
The drive is braked to standstill via the deceleration ramp C105 and generates a holding torque.
l The function can be controlled by three inputs
– Control word CAN−CTRL bit 3 of CAN−IN1
– Control word AIF−CTRL bit 3 of AIF−IN
– Control word C0135 bit 3
l All inputs are linked by an OR−operation.
l C0136/1 displays the control word C0135