Lenze EVS9332xS - Manual (Page 262)

Appendix
5.2 Index
5−8
l
EDSVS9332S−EXT EN 2.0
OR operation (OR), 3−135
Oscilloscope function (OSZ), 3−138
P
Parameter set changeover (PAR), 3−61
Phase adjustment, 2−17
Phase integrator (PHINT), 3−150
− constant input value, 3−152 , 3−153
− Input value with sign reversal, 3−154
− Scaling of PHINTx−OUT, 3−155
Phase offset, 2−17 , 2−27
Phase trimming, 2−16
Phase−synchronous operation, 2−13
Positioning control with driftfree standstill, 2−13
Process controller (PCTRL1)
− Control characteristic, 3−143
− Dancer position, tension, pressure controller, 3−142
− Ramp function generator, 3−144
Processing table, 3−10
− Frequent faults, 3−11
Profile generator, 2−30 , 2−33 , 3−159
− gearbox ratio, 2−33
− home position offset, 2−33
− homing speed, 2−33
− homing Ti time, 2−33
Q
QSP (quick stop), 2−10 , 3−109
QSP at the master, 2−17
QSP at the slave, 2−20 , 2−23
QSP at the slave 0, 2−17
Quick stop (QSP), 2−10 , 3−58
Quick stop QSP, 3−109
R
Ramp function generator, 3−144
Ramp generator(RFG), 3−164
Referencing, 2−30
Resetting a fault, 2−10
Restart protection, 3−120
S
S ramp, PT1 element, 3−134
S−shaped ramp function generator (SRFG), 3−167
S−shaped ramp function generator characteristic,
2−7
Safety instructions
− Definition, 1−6
− Structure, 1−6
Sample and hold function (S&H), 3−166
Selection of direction of rotation, 2−8
Setpoint conditioning of the slave, 2−20
Setpoint inversion, Ramp function generator, main
setpoint, 3−133
Setting the integral component, 3−106
Signal conversion (CONV), 3−47
Slave, 2−18
Speed control, 2−6 , 4−4 , 4−7 , 4−9 , 4−12 ,
4−14
− acceleration and deceleration times, 2−7
− additional acceleration and deceleration times, 2−7
− additional setpoint, 2−7
− additional torque setpoint, 2−9
− controller inhibit, 2−10
− current master value, 2−6
− inverting the main setpoint, 2−7
− JOG setpoint, 2−6
− main setpoint, 2−6
− resetting a fault, 2−10
− S−shaped ramp function generator characteristic, 2−7
− selection of direction of rotation, 2−8
− setpoint selection, 2−6
− speed limit, 2−9
Speed controller, 3−106
− Setting the integral component, 3−106
Speed conversion (CONVPP), 3−52
Speed limit, 2−9
Speed limitation, 2−12
Speed ratio synchronism, 2−25
Speed setpoint conditioning (NSET), 3−130
− Additional setpoint, 3−134
− JOG setpoints, 3−132
− Main setpoint, 3−131
− S ramp, PT1 element, 3−134
− Setpoint inversion, Ramp function generator, main setpoint,
3−133
Speed setpoint limitation, 3−107
Speed synchronism, 2−25