Lenze EVS9332xS - Manual (Page 41)

Configuration
Basic configurations
2.2.6 Angular synchronism
2−29
l
EDSVS9332S−EXT EN 2.0
Use of TOUCH−PROBE
Besides the zero pulses of the inputs X9 and the corresponding feedback system, the zero pulse
evaluation can also be derived from the digital inputs X5/E4 (actual value) and X5/E5 (setpoint). The
function is switched from zero pulse evaluation of the encoder (or resolver) to the evaluation of the
inputs X5/E4 and X5/E5 by C0532 = 2.
IMPORTANT:
The inputs X5/E4 and X5/E5 are assigned with TRIP−Set or TRIP−Reset as standard. In this case, the
input terminals must be removed from the function block DCTRL (drive control).
Use of zero pulse for the setpoint and TOUCH−PROBE for the actual value
The zero pulses can also be evaluated via a zero pulse at setpoint input X9 and a TOUCH−PROBE
input X5/E4 (actual value). The function is switched on with C0532 = 3.
X7
R M
1:5
Master Slave
R M
Touch probe
X9
Ctrl. enable
V withdrawal
9300 Master 9300 slave
28 E4 E5 39 A1 A4 A2
Gearbox Gearbox
Stretch factor
X10 X10
=
+ −
1
2
X7
n
act
=0
1:5
Ctrl. enable
28 E4 E5 39 A1 A4 A2
n act =0
Fig. 2−5 Example for using TOUCH−PROBE