Lenze EVS9332xS - Manual (Page 225)

Function library
Function blocks
3.2.62 Storage block (STORE)
3−173
l
EDSVS9332S−EXT EN 2.0
3.2.62.1 STORE1 control via TP input E5
The trigger signal STORE1−TP−INH indicates a triggering done via the TP input E5 with a HIGH signal
(LOW−HIGH edge at X5/E5). At the same time it is signalled with STORE1−TP−INH that the triggering
is deactivated and must be reset to the active state. This can be done via
l STORE1−RESET = HIGH
l STORE1−ENTP = LOW−HIGH edge
l STORE1−ENWIN = HIGH and the comparison of phase signals
Comparison of phase signals
A phase signal is created from the speed signal at STORE1−MASKI and is compared with the phase
signal at STORE1−MASKV.
If the condition | STORE1−MASKI | w STORE1−MASKV
is fulfilled,
l the TP input E5 is enabled for the next triggering with STORE1−ENWIN = HIGH,
l the integrator for the speed signal at STORE1−MASKI is reset.