Wiring your safe torque-off circuit, European union directives – Rockwell Automation 2097-Vxxx Kinetix 350 Single-axis EtherNet/IP Servo Drive User Manual User Manual
Page 105
Rockwell Automation Publication 2097-UM002C-EN-P - December 2013
105
Kinetix 350 Drive Safe Torque-off Feature Chapter 6
Wiring Your Safe Torque-off
Circuit
This section provides guidelines for wiring your Kinetix 350 safe torque-off drive
connections.
European Union Directives
If this product is installed within the European Union or EEC regions and has
the CE mark, the following regulations apply.
For more information on the concept of electrical noise reduction, refer to
System Design for Control of Electrical Noise Reference Manual, publication
EMC Directive
This unit is tested to meet Council Directive 2004/108/EC Electromagnetic
Compatibility (EMC) by using these standards, in whole or in part:
• EN 61800-3 - Adjustable Speed Electrical Power Drive Systems,
Part 3 - EMC Product Standard including specific test methods
• EN 61000-6-4 EMC - Emission Standard, Part 2 - Industrial Environment
• EN 61000-6-2 EMC - Immunity Standard, Part 2 - Industrial
Environment
The product described in this manual is intended for use in an industrial
environment.
CE Conformity
Conformity with the Low Voltage Directive and Electromagnetic Compatibility
(EMC) Directive is demonstrated by using harmonized European Norm (EN)
standards published in the Official Journal of the European Communities. The
safe torque-off circuit complies with the EN standards when installed according
instructions found in this manual.
CE Declarations of Conformity are available online at:
.
Low Voltage Directive
These units are tested to meet Council Directive 2006/95/EC Low Voltage
Directive. The EN 60204-1 Safety of Machinery-Electrical Equipment of
Machines, Part 1-Specification for General Requirements standard applies in
whole or in part. Additionally, the standard EN 50178 Electronic Equipment for
use in Power Installations apply in whole or in part.