Rockwell Automation 2097-Vxxx Kinetix 350 Single-axis EtherNet/IP Servo Drive User Manual - Manual (Page 84)

84 Rockwell Automation Publication 2097-UM002C-EN-P - December 2013
Chapter 5 Configure and Start Up the Kinetix 350 Drive System
Configure the Logix5000
EtherNet/IP Controller This procedure assumes that you have wired your Kinetix 350 drive system and
are using Logix Designer application version 21.00.00 or later.
For help using Logix Designer application as it applies to configuring the
ControlLogix EtherNet/IP controller, refer to
Additional Resources on page 10 .
Configure the Logix5000 Controller
Follow these steps to configure the Logix5000 controller.
1. Apply power to your Logix5000 controller containing the EtherNet/IP
port and open your Studio 5000 environment.
2. Click New Project.
The New Project dialog box appears.
3. Select the controller you are using for your project and click Next.