Rockwell Automation 2097-Vxxx Kinetix 350 Single-axis EtherNet/IP Servo Drive User Manual - Manual (Page 18)

18 Rockwell Automation Publication 2097-UM002A-EN-P - December 2013
Chapter 2 Install the Kinetix 350 Drive System
• Use 2090 series motor feedback cables or use connector kits and properly
terminate the feedback cable shield. Drive-to-motor power and feedback
cables must not exceed 20 m (65.6 ft).
Refer to the System Design for Control of Electrical Noise Reference Manual,
publication
GMC-RM001 , to better understand the concept of electrical noise
reduction.
IMPORTANT System performance was tested at these cable length specifications. These
limitations are also a CE requirement.