Verify the firmware upgrade – Rockwell Automation 2097-Vxxx Kinetix 350 Single-axis EtherNet/IP Servo Drive User Manual User Manual
Page 150
Advertising
150
Rockwell Automation Publication 2097-UM002C-EN-P - December 2013
Appendix B Upgrade the Kinetix 350 Drive Firmware
Verify the Firmware Upgrade
Follow these steps to verify your firmware upgrade was successful.
1. Open your RSLinx software.
2. From the Communications pull-down menu, choose RSWho.
3. Expand your Ethernet node, Logix5000 backplane, and EtherNet/IP
network module.
4. Right-click the drive module and choose Device Properties.
The Device Properties dialog box appears.
5. Verify the new firmware revision level.
6. Click Close.
TIP
Verifying the firmware upgrade is optional.
Advertising