Rockwell Automation 2097-Vxxx Kinetix 350 Single-axis EtherNet/IP Servo Drive User Manual - Manual (Page 79)

Rockwell Automation Publication 2097-UM002C-EN-P - December 2013 79
Configure and Start Up the Kinetix 350 Drive System Chapter 5
Status Indicators
The Kinetix 350 drive has four status indicators and a four-digit display on the
top front panel as shown below. These status indicators and the display are used
to monitor the system status, activity, and troubleshoot faults.
Figure 45 - Front Panel Display
Table 36 - Module State Status Indicator
Table 35 - Status Indicators
Status
Indicator
Function Description
D Data entry Yellow status indicator flashes when changing.
N Network state
Indicates the state of the Network. See Network State
Status Indicator on page 80 . The bicolored status indicator
shows red, green, or amber.
M Module state
Indicates the state of the Network. See Module State
Status Indicator on page 79 . The bicolored status indicator
shows red, green, or amber.
A Axis state
Indicates the state of the Network. See Axis State Status
Indicator on page 80 . The bicolored status indicator shows
red, green, or amber.
Status Indicator State
Off Power off
Flash red/green Drive self-testing
Flashing green Standby
Solid green Operational
Flashing red Major recoverable fault
Solid red Major unrecoverable fault