Rockwell Automation 2097-Vxxx Kinetix 350 Single-axis EtherNet/IP Servo Drive User Manual - Manual (Page 144)

144 Rockwell Automation Publication 2097-UM002C-EN-P - December 2013
Appendix B Upgrade the Kinetix 350 Drive Firmware
Configure Logix5000 Communication
This procedure assumes that your communication method to the Logix5000
controller by using the Ethernet protocol. It is also assumed that your Logix5000
Ethernet module has already been configured.
For more information, refer to the ControlLogix System User Manual,
publication
1756-UM001 .
Follow these steps to configure Logix5000 communication.
1. Open your RSLinx Classic software.
2. From the Communications pull-down menu, choose Configure Drivers.
The Configure Drivers dialog box appears.
3. From the Available Drive Types pull-down menu, choose Ethernet devices.
4. Click Add New.
The Add New RSLinx Classic Driver dialog box appears.
5. Type the new driver name.