Rockwell Automation 2097-Vxxx Kinetix 350 Single-axis EtherNet/IP Servo Drive User Manual - Manual (Page 77)

Rockwell Automation Publication 2097-UM002C-EN-P - December 2013 77
Chapter
5
Configure and Start Up the
Kinetix 350 Drive System
Topic Page
Keypad Input 78
Configure the Kinetix 350 Drive Ethernet IP Address 81
Configure the Logix5000 EtherNet/IP Controller 84
Apply Power to the Kinetix 350 Drive 93
Test and Tune the Axes 94
Disable EnableInputChecking by Using a Logix Designer Message Instruction 100
TIP Before you begin make sure you know the catalog number for the
drive, the Logix5000 controller, and the servo motor/actuator in your
motion control application.