Rockwell Automation 2097-Vxxx Kinetix 350 Single-axis EtherNet/IP Servo Drive User Manual - Manual (Page 24)

24 Rockwell Automation Publication 2097-UM002A-EN-P - December 2013
Chapter 2 Install the Kinetix 350 Drive System
Minimum Clearance Requirements
This section provides information to assist you in sizing your cabinet and
positioning your Kinetix 350 system components.
Figure 3 illustrates minimum clearance requirements for proper airflow and
installation:
• Additional clearance is required depending on the accessory items
installed.
• An additional 9.7 mm (0.38 in.) clearance is required left of the drive if the
I/O expansion terminal block is used.
• An additional 26 mm (1.0 in.) clearance is required right of the drive when
the heatsink is present.
• An additional 36 mm (1.42 in.) is required right of the drive when the
side-mount line filter is present. An additional 50 mm (2.0 in.) is required
behind the drive when the rear-mount line filter is present.
• An additional 5.0 mm (0.19 in.) clearance is required in front of the drive
when the 2090-K2CK-D15M feedback connector kit is used.
• Additional clearance is required for the cables and wires connected to the
top, front, and bottom of the drive.
• An additional 150 mm (6.0 in.) is required when the drive is mounted
adjacent to noise sensitive equipment or clean wireways.
Refer to Kinetix 350 Drive Power Specifications in Kinetix Servo Drives
Specifications Technical Data, publication
GMC-TD003 for Kinetix 350 drive
dimensions.
Figure 3 - Minimum Clearance Requirements
Refer to page 23 for power dissipation specifications.
IMPORTANT Mount the module in an upright position as shown. Do not mount the drive
module on its side.
A
25.0 mm (1.0 in.) Clearance
for Airflow and Installation
3 mm (0.12 in.)
Side Clearance
3 mm (0.12 in.)
Side Clearance
25.0 mm (1.0 in.) Clearance
for Airflow and Installation
Drive
Cat. No.
A
2097-V31PR0-LM 185 (7.29)
2097-V31PR2-LM 185 (7.29)
2097-V32PR0-LM 230 (9.04)
2097-V32PR2-LM 230 (9.04)
2097-V32PR4-LM 230 (9.04)
2097-V33PR1-LM 185 (7.29)
2097-V33PR3-LM 185 (7.29)
2097-V33PR5-LM 185 (7.29)
2097-V33PR6-LM 230 (9.04)
2097-V34PR3-LM 185 (7.29)
2097-V34PR5-LM 185 (7.29)
2097-V34PR6-LM 230 (9.04)