Basler Electric DGC-2020ES - Manual (Page 131)

9469200990 Rev C 123
Name Description Symbol
Contact
Expansion
Module
Contact
Expansion
Module Comm
Fail True when communication from the CEM-2020 to the
DGC-2020ES has been lost.
Contact
Expansion
Module
Contact
Expansion
Modules
Hardware
Mismatch True when the connected CEM-2020 does not have
the same number of outputs as defined on the System
Parameters, Remote Module Setup screen in
BESTCOMSPlus.
Coolant Temp
Sender Fail True when the Coolant Temp Sender Fail is configured
as a pre-alarm and the activation delay has expired.
DEF
Inducement This is the lowest level of inducement not to operate
the engine when Diesel Exhaust Fluid (DEF) is low or
of poor quality or there is a problem with the Exhaust
After Treatment System (EATS). The engine is
operating in a reduced power mode. Eventually the
level of inducement will be increased unless the
problem with the DEF or malfunction in the EATS is
corrected.
DEF Low
Severe True when the engine ECU reports via CAN Bus that
Diesel Exhaust Fluid (DEF) is at a level below 8%.
DEF Fluid Low True when the engine ECU reports via CAN Bus that
the Diesel Exhaust Fluid (DEF) is at a level between 8
and 23%.
DEF
Inducement
Override This pre-alarm indicates a temporary override of
inducement not to operate the engine. This is set by
the ECU and is not a user setting.
DEF Pre-severe
Inducement This pre-alarm indicates a high level of inducement not
to operate the engine due to low or poor quality Diesel
Exhaust Fluid (DEF), or a malfunction in the Exhaust
After Treatment System (EATS). The engine may
operate in a reduced power mode, or for a limited time,
after which it will enter a state of severe inducement
unless the problem with the DEF or malfunction in the
EATS is corrected.
DEF Severe
Inducement This pre-alarm indicates the highest level of
inducement not to operate the engine due to low or
poor quality Diesel Exhaust Fluid (DEF), or a
malfunction in the Exhaust After Treatment System
(EATS). The engine may operate in a reduced power
mode, or for a limited time, or may be prevented from
starting by the ECU until the problem is corrected. A
service tool may be required to restart the engine.
Diag Trouble
Code True when a Diagnostic Trouble Code exists.
DPF
Regenerate
Disabled True when the Diesel Particulate Filter (DPF) lamp
status broadcast over CAN Bus indicates that DPF
regeneration is inhibited.
DGC-2020ES BESTlogic
™Plus