Basler Electric DGC-2020ES - Manual (Page 70)

62 9469200990 Rev C
Table 5. Descriptions of Call-outs in Figure 26.
Call-
Out
Symbol Description
A
Holding the left mouse button down on a metering tab and dragging it to one
of the four arrow boxes will place the metering tab inside the selected window
on the location selected. To place the metering tab as a tab inside the
selected window, drop it on the tabs button in the center of the arrow buttons.
B
Holding the left mouse button down on a metering tab and dragging it to this
arrow box will place it across the top of the screen. Click on the (thumbtack)
to dock it on the top bar. To display a screen that is docked, simply use the
mouse to hover the pointer over the tab on the top bar.
C
Holding the left mouse button down on a metering tab and dragging it to this
arrow box will place it across the side of the screen. Click on the
(thumbtack) to dock it on the side bar. To display a screen that is docked,
simply use the mouse to hover the pointer over the tab on the side bar.
D
Holding the left mouse button down on a metering tab and dragging it to this
arrow box will place it across the bottom of the screen. Click on the
(thumbtack) to dock it on the bottom bar. To display a screen that is docked,
simply use the mouse to hover the pointer over the tab on the bottom bar.
E
Holding the left mouse button down on a metering tab and dragging it
anywhere other than an arrow box will place it as a floating metering screen.
This floating screen can later be closed by clicking on the
in the upper right
corner. It can also be dragged to one of the arrow boxes used for docking.
BESTspace
™
BESTspace provides the ability to manage customized workspaces. Refer to the BESTCOMSPlus
chapter for more information on BESTspace.
Engine
The Engine metering screen (Figure 27) provides information and metering of engine components.
Parameters that do not apply to your engine are marked as either NS (not sent) or NA (not applicable).
The Engine screen is found in the BESTCOMSPlus Metering Explorer. If using the front panel, navigate to
Metering > Engine.
Figure 27. Metering Explorer, Engine Screen
Metering DGC-2020ES