PLANET XGSW-28040HP - Manual (Page 154)

Command Guide of XGSW-28040HP
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # shutdown
4.2.65.112 spanning-tree
Command:
spanning-tree
spanning-tree Spanning Tree protocol
Default:
Disabled
Usage Guide:
To enable STP for specific interface
Example:
To enable STP for GigabitEthernet X/X
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # spanning-tree
4.2.65.113 spanning-tree auto-edge
Command:
spanning-tree auto-edge
spanning-tree Spanning Tree protocol
auto-edge Auto detects edge status
Default:
Enabled
Usage Guide:
To enable Auto Edge of CIST Normal Port Configuration for specific interface
Example:
To enable Auto Edge of CIST Normal Port Configuration for GigabitEthernet X/X
Switch# configure terminal
-154-