PLANET XGSW-28040HP - Manual (Page 89)

Command Guide of XGSW-28040HP
<Ivid : vlan_id> Internal VLAN ID
interface Setup NNI
learning Setup learning
policer Policer (ingress bandwidth profile)
<PolicerId : 1-2048> Policer ID
<vlan_list> List of VLANs
discard Map to policer discarding all frames
none Map to policer allowing all frames
Default:
0
Usage Guide:
To update an ID for Ethernet Virtual Circuits (EVC).
Example:
To update Ethernet Virtual Circuits (EVC identifier: 1, EVC VLAN ID: 10).
Switch# configure terminal
Switch (config)# evc update 1 vid 10
4.2.57 exit
Command:
exit
Default:
N/A
Usage Guide:
To exit configure terminal mode.
Example:
To exit configure terminal mode.
Switch# configure terminal
Switch (config)# exit
#
-89-