PLANET XGS3-24040 - Manual (Page 190)

Chapter 21 Layer 3 Forward Configuration
21-20
1. Configure static ARP
Command Explanation
VLAN Port Mode
arp <ip_address> <mac_address>
{interface [ethernet] <portName>}
no arp <ip_address>
Configures a static ARP entry; the no
command deletes a ARP entry of the
specified IP address.
2. Configure proxy ARP
3. Clear dynamic ARP
Command Explanation
Admin mode
clear arp-cache
The command clear arp-cache clears the
content of current ARP table, but it does not
clear the current static ARP table.
4. Select hash arithmetic
Command Explanation
Global mode
l3 hashselect
[<crc16l|crc16u|crc32l|crc32u|lsb>]
Set the hash arithmetic of the layer 3 table.
This command refers to ARP table list storage
in the hardware, the implement need to guide
by the technique specialist. The detail
information please refer to the interrelated
Command Guide.
5. Clear the statistic information of ARP message
Command Explanation
Admin mode
clear arp traffic
Clear the statistic information of ARP
messages of the switch.
Command Explanation
VLAN Port Mode
ip proxy-arp
no ip proxy-arp
Enables the proxy ARP function for Ethernet
ports: the no command disables the proxy
ARP.