PLANET XGS3-24040 - Manual (Page 313)

Chapter 39 BGP
39-7
7. Configure EGBP Multi-Hop
If the connections with outer neighbors are not direct, the following command can configure neighbor
Multi-Hop.
Command Explanation
BGP configuration mode
neighbor {<ip-address>|<TAG>} ebgp-multihop
[<1-255>]
no neighbor {<ip-address>|<TAG>}
ebgp-multihop [<1-255>]
Configure the allowance of EBGP
connection with other networks
that are not connected directly;
the no neighbor
{<ip-address>|<TAG>}
ebgp-multihop [<1-255>]
command cancels the setting.
8. Configure BGP session identifier
Command Explanation
BGP configuration mode
bgp router-id <ip-address>
no bgp router-id
Configure the router-id value; the no bgp
router-id command recovers the default
value.
9. Configure the BGP Version
Command Explanation
BGP configuration mode
neighbor {<ip-address> | <TAG>} version
<value>
no neighbor {<ip-address> | <TAG>} version
Set the version used by BGP
neighbors; the no neighbor
{<ip-address> | <TAG>} version
command recovers default
setting. Presently only supporting
version 4
th
.
Ⅱ．Advanced BGP configuration tasks
1．Use Route Maps to Modify Route
Command Explanation
BGP configuration mode
neighbor { <ip-address> | <TAG> } route-map
<map-name > {in | out}
no neighbor { <ip-address> | <TAG> }
route-map <map-name > {in | out}
Apply a route map to incoming or
outgoing routes; the no neighbor
{ <ip-address> | <TAG> }
route-map <map-name > {in |
out} command cancels the
settings of routing maps.