PLANET XGS3-24040 - Manual (Page 428)

Chapter 44 IPv6 Multicast Protocol
44-26
3）Configure overtime of MLD query
3、 Shut down MLD Protocol
1. Start MLD Protocol
There is no special command for starting MLD Protocol on EDGECORE series layer 3 switches. MLD
Protocol will automatically start up as long as any IPv6 multicast protocol is started on corresponding
interface.
Command Explanation
Global Mode
Ipv6 pim multicast-routing
To start Global IPv6 Multicast Protocol, the
precondition of starting MLD Protocol. The NO
operation of corresponding command shuts ipv6
multicast protocol and MLD Protocol. (Required)
Command Explanation
Port Configuration Mode
ipv6 pim dense-mode | ipv6 pim
sparse-mode
Start MLD Protocol. The NO operation of
corresponding command shuts MLD Protocol.
(Required)
2. Configure MLD auxiliary parameters
（1）Configure MLD group parameters
1） Configure MLD group filter conditions
Command Explanation
Port Configuration Mode
ipv6 mld access-group
<acl_name>
no ipv6 mld access-group
Configure the filter conditions of interface for
MLD group; the NO operation of this command
cancels filter conditions.
（2）Configure MLD Query parameters
1）Configure interval time for MLD to send query messages
2）Configure the maximum response time of MLD query
3）Configure the overtime of MLD query
Command Explanation
Port Configuration Mode
ipv6 mld query-interval <time_val>
no ipv6 mld query-interval
Configure the interval of MLD query messages
sent periodically; the NO operation of this
command restores the default value.