PLANET XGS3-24040 - Manual (Page 259)

Chapter 35 RIP
35-4
neighbor <A.B.C.D>
no neighbor <A.B.C.D>
Specify the IP address of the neighbor router
needs point-transmitting; the no neighbor
<A.B.C.D> command cancels the appointed
router.
passive-interface<ifname|vlan>
no passive-interface<ifname|vlan >
Block the RIP broadcast on specified pot and the
RIP data packet is only transmittable among
Layer 3 switch configured with neighbor. The no
passive-interface<ifname|vlan > command
cancels the function.
（2）Configure RIP route parameters
1）Configure route introduction (default route metric, configure routes of the other protocols to be introduced in
RIP)
Command Explanation
Router Configuration Mode
default-metric <value>
no default-metric
Sets the default route metric for route to be
introduced; the “no default-metric” command
restores the default setting.
redistribute {kernel |connected| static|
ospf | isis| bgp} [metric<value>]
[route-map<word>]
no redistribute {kernel |connected|
static| ospf | isis| bgp} [metric<value>]
[route-map<word>]
Redistribute the routes distributed in other
routing protocols into the RIP data packet; the
no redistribute {kernel |connected| static|
ospf | isis| bgp} [metric<value>]
[route-map<word>] command cancels the
distributed route of corresponding protocols.
default-information originate
no default-information originate
Generate a default route to the RIP protocol; the
no default-information originate command
cancels the feature.
2）Configure interface authentication mode and password
Command Explanation
Interface configuration mode
ip rip authentication mode { text| md5}
no ip rip authentication mode [text|
md5]
Sets the authentication method; the no ip rip
authentication mode [text| md5] command
cancels the authentication action.
ip rip authentication string <text>
no ip rip authentication string
Sets the authentication key; the no ip rip
authentication string command means no key
is needed.
ip rip authentication key-chain
<name-of-chain>
no ip rip authentication key-chain
[<name-of-chain>]
Sets the key chain used in authentication, the no
ip rip authentication key-chain
[<name-of-chain>] command means the key
chain is not used.