PLANET XGS3-24040 - Manual (Page 363)

Chapter 43 Ipv4 Multicast Protocol
43-17
43.4.3.2 Enabling MSDP
MSDP should be enabled before various MSDP functions can be configured.
1. Enable the MSDP function
2. Configure MSDP
1. Enabling MSDP
Commands Explanation
Global Configuration Mode
router msdp
no router msdp
To enable MSDP. The no form of this
command will disable MSDP globally.
2. Configuration of MSDP parameters
Commands Explanation
MSDP Configuration Mode
connect-source <interface-type>
<interface-number>
no connect-source
To configure the Connect-Source interface for
MSDP Peer. The no form of this command
will remove the configured Connect-Source
interface.
default-rpf-peer <peer-address> [ rp-policy
<acl-list-number> | <word> ]
no default-rpf-peer
To configure static RPF Peer. The no form of
this command will remove the configured
RPF Peer.
originating-rp <interface-type>
<interface-number>
no originating-rp
To configure Originator-RP. The no form of
this command will remove the configured
Originator-RP.
ttl-threshold <ttl>
no ttl-threshold
To configure the TTL value. The no form of
this command will remove the configured TTL
value.
43.4.4 Configuration of MSDP Entities
43.4.4.1 Creation of MSDP Peer
Commands Explanation
MSDP Configuration Mode
peer <peer-address>
no peer <peer-address>
To create a MSDP Peer. The no form of this
command will remove the configured MSDP
Peer.