PLANET XGS3-24040 - Manual (Page 41)

XGS3 Configuration Guide
3-15
Figure 3-8 Telnet Configuration Interface
3.1.2.2 Management via HTTP
To manage the switch via HTTP, the following conditions should be met:
1) Switch has an IPv4/IPv6 address configured;
2) The host IPv4/IPv6 address (HTTP client) and the switch’s VLAN interface IPv4/IPv6 address are in
the same network segment;
3) If 2) is not met, HTTP client should connect to an IPv4/IPv6 address of the switch via other devices,
such as a router.
Similar to management the switch via Telnet, as soon as the host succeeds to ping/ping6 an IPv4/IPv6
address of the switch and to type the right login password, it can access the switch via HTTP. The
configuration list is as below:
Step 1: Configure the IP addresses for the switch and start the HTTP server function on the switch.
For configuring the IP address on the switch through out-of-band management, see the telnet management
chapter.
To enable the WEB configuration, users should type the CLI command IP http server in the global mode as
below:
Switch>enable
Switch#config
Switch(config)#ip http server