PLANET XGS3-24040 - Manual (Page 319)

Chapter 39 BGP
39-13
neighbor { <ip-address> | <TAG> }
default-originate
no neighbor { <ip-address> | <TAG> }
default-originate
Permit sending default route 0.0.0.0;
the no neighbor { <ip-address> |
<TAG> } default-originate
command cancels sending default
route.
12． Configure BGP’s MED Value
（1） Configure MED value
Command Explanation
Route map configuration command
set metric <metric-value>
no set metric
Configure metric value; the no set metric
command recovers the default value.
（2） Apply route selection based on MED according to the path from different AS
Command Explanation
BGP configuration mode
bgp always-compare-med
no bgp always-compare-med
Permit the MED comparison from different
AS; the no bgp always-compare-med
command forbids the comparison.
13． Configure BGP routing redistribution
Command Explanation
BGP configuration mode
redistribute { connected | static | rip |
ospf} [metric <metric>] [route-map
<NAME>]
no redistribute { connected | static | rip
| ospf}
Redistribute IGP routes to BGP and may
specify the redistributed metric and route
reflector; the no redistribute { connected |
static | rip | ospf} command cancels the
redistribution.
14． Configure Route Dampening
Command Explanation
BGP configuration mode
bgp dampening [<1-45>] [<1-20000>
<1-20000> <1-255>] [<1-45>]
no bgp dampening
Enable BGP route dampening and apply the
specified parameters; the no bgp
dampening command stops route
dampening