PLANET XGS3-24040 - Manual (Page 442)

Chapter 46 ACL Configuration
46-4
{{<dIpAddr> <dMask>} | any-destination |
{host-destination <dIpAddr>}} [d-port { <dPort> |
range <dPortMin> <dPortMax> }] [precedence
<prec>] [tos <tos>][time-range<time-range-name>]
specified number does not exist,
then an access-list will be created
using this number.
access-list <num> {deny | permit} {eigrp | gre | igrp |
ipinip | ip | ospf | <protocol-num>} {{<sIpAddr>
<sMask>} | any-source | {host-source <sIpAddr>}}
{{<dIpAddr> <dMask>} | any-destination |
{host-destination <dIpAddr>}} [precedence <prec>]
[tos <tos>][time-range<time-range-name>]
Creates a numbered IP extended
IP access rule for other specific IP
protocol or all IP protocols; if the
numbered extended access-list of
specified number does not exist,
then an access-list will be created
using this number.
no access-list <num>
Deletes a numbered extensive IP
access-list.
(3) Configuring a standard IP access-list basing on nomenclature
a. Create a name-based standard IP access-list
Command Explanation
Global Mode
ip access-list standard <name>
no ip access-list standard <name>
Creates a standard IP
access-list based on
nomenclature; the “no ip
access-list standard
<name>“ command deletes the
name-based standard IP
access-list.
b. Specify multiple “permit” or “deny” rules
Command Explanation
Standard IP ACL Mode
[no] {deny | permit} {{<sIpAddr> <sMask>} |
any-source | {host-source <sIpAddr>}}
Creates a standard
name-based IP access rule; the
“no” form command deletes the
name-based standard IP
access rule.
c. Exit name-based standard IP ACL configuration mode
Command Explanation
Standard IP ACL Mode
exit
Exits name-based standard IP
ACL configuration mode.