4 ipv6 dcscm troubleshooting, 6 mld, 1 introduction to mld – PLANET XGS3-24040 User Manual

Page 427: 2 mld configuration task list

Advertising
background image

Chapter 44 IPv6 Multicast Protocol

44-25

44.5.4 IPv6 DCSCM Troubleshooting

IPv6 DCSCM module acts like ACL, so most problems are caused by improper configuration. Please read the

instructions above carefully.

44.6 MLD

44.6.1 Introduction to MLD

MLD (Multicast Listener Discovery) is the multicast group member (receiver) discovery protocol serving IPv6

multicast. It is similar to IGMP Protocol in IPv4 multicast application. Correspondingly, MLD Protocol version1

is similar to IGMP Protocol version2, and MLD Protocol version2 is similar to IGMP Protocol version3. Current

firmware supports MLDv1/ MLDv2.

The IPv6 multicast hosts can join or leave from multicast group at any location, any time, regardless of the

total number of group members. It is unnecessary and impossible for multicast switch to store the relationship

among all host members. Multicast switch simply finds out via MLD protocol if there are receivers of certain

multicast group on the network segment connected to each port. The only thing host need to do is to keep the

record of which multicast groups it joined.

MLD is unsymmetrical between host and switch: the host needs to respond the MLD query message of

multicast switch with membership report message; the switch periodically sends membership query message

and determines if there is host joining a specific group in its subnetworks according to the response message

received, and after it receives the report of a host quitting from the group, it sends out the query for the group

to confirm if there is no member left in it.

There are three types of protocol messages of MLD Protocol, that is, Query, Report and Done (which is

corresponding to Leave of IGMPv2). Like IGMPV2, the Query messages include General Query and Specific

Group Query. General Query uses the multicast address FF02::1 of hosts as destination address, the group

address is 0; and Specific Group Query use its group address as destination address. The multicast

addresses of MLD use 130, 131 and 132 as data types denoting the three kinds of messages mentioned

above. Other logic is basically same as IGMPv2.

MLD protocol version2 use FF02::16 as destination address of membership report, and 143 as data type. The

other logic of MLD Protocol version2 is similar to IGMP Protocol version3.

44.6.2 MLD Configuration Task List

1、 Start MLD (Required)

2、 Configure MLD auxiliary parameters (Required)

(1)Configure MLD group parameters

1)Configure MLD group filter conditions

(2)Configure MLD query parameters

1)Configure the interval of MLD sending query message

2)Configure the maximum response time of MLD query

Advertising