PLANET XGS3-24040 - Manual (Page 358)

Chapter 43 Ipv4 Multicast Protocol
43-12
(2) Configure global PIM-SM parameter
1) Configure the switch as a candidate BSR
Command Explanation
Global Configuration Mode
ip pim bsr-candidate {vlan
<vlan-id>|
<ifname>}[ <mask-length>][ <priorit
y> ]
no ip pim bsr-candidate
This command is the global candidate BSR
configuration command, which is used to
configure the information of PIM-SM candidate
BSR so that it can compete for BSR router with
other candidate BSR. The “no ip pim
bsr-candidate” command cancels the
configuration of BSR.
2) Configure the switch as a candidate RP
Command Explanation
Global Configuration Mode
ip pim rp-candidate { vlan
<vlan-id>| lookback<index>
<ifname>} [<A.B.C.D>][<priority>]
no ip pim rp-candiate
This command is the global candidate RP
configuration command, which is used to
configure the information of PIM-SM candidate
RP so that it can compete for RP router with
other candidate RP. The “no ip pim
rp-candidate” command cancels the
configuration of RP.
3) Configure static RP
Command Explanation
Global Configuration Mode
ip pim rp-address <A.B.C.D>
[<A.B.C.D/M>]
no ip pim rp-address <A.B.C.D>
{<all>|<A.B.C.D/M>}
The command is the multicast group
configuration static RP of the globally or
multicast address range. The no form of this
command will remove the configuration for the
static RP.
4. Disable PIM-SM Protocol
Command Explanation
Interface Configuration Mode
no ip pim sparse-mode | no ip pim
multicast-routing(Global
configuration mode)
To disable the PIM-SM protocol.