PLANET XGS3-24040 - Manual (Page 406)

Chapter 44 IPv6 Multicast Protocol
44-4
ipv6 pim bsr-border
no ipv6 pim bsr-border
To configure the interface as the boundary of
PIM-DM6 protocol. On the boundary interface,
STATE REFRESH messages will not be sent or
received. The network connected the interface is
considered as directly connected network. The
no form of this command will remove the
configuration.
4) Configure the management boundary
Command Explanation
Interface Configuration Mode
ipv6 pim scope-border
<500-599>|<acl_name>
no ipv6 pim scope-border
To configure PIM-DM6 management boundary
for the interface and apply ACL for the
management boundary. With default settings,
ffx0::/13 is considered as the scope of the
management group. If ACL is configured, then
the scope specified by ACL permit command is
the scope of the management group. acl_name
should be standard IPv6 ACL name. The no
form of this command will remove the
configuration.
4. Disable PIM-DM protocol
Command Notes
Interface Configuration Mode
no ipv6 pim dense-mode To disable PIM-DM for the specified interface.
Global Configuration Mode
no ipv6 pim multicast-routing To disable PIM-DM globally.
44.1.3 PIM-DM6 Typical Application
As shown in the following figure, add the Ethernet interfaces of Switch A and Switch B to corresponding vlan,
and start PIM-DM Protocol on each vlan interface.