PLANET XGS3-24040 - Manual (Page 411)

Chapter 44 IPv6 Multicast Protocol
44-9
ipv6 pim hello-holdtime <value>
no ipv6 pim hello-holdtime
To configure the value of the holdtime field in the
PIM-SM hello messages. The no form of this
command will restore the hold time to the default
value.
3) Configure ACL for PIM-SM6 neighbors
Command Explanation
Interface Configuration Mode
ipv6 pim neighbor-filter
<acess-list-name>
no ipv6 pim neighbor-filter
<acess-list-name>
To configure ACL to filter PIM-SM6 neighbor. If
session to the neighbor has been denied by
ACL, then the sessions that have been set up
will be discarded immediately and new sessions
will not be set up.
4) Configure the interface as the boundary interface of the PIM-SM6 protocol
Command Explanation
Interface Configuration Mode
ipv6 pim bsr-border
no ipv6 pim bsr-border
To configure the interface as the boundary of
PIM-SM6 protocol. On the boundary interface,
BSR messages will not be sent or received. The
network connected the interface is considered
as directly connected network. The no form of
this command will remove the configuration.
5) Configure the interface as the management boundary of the PIM-SM6 protocol
Command Explanation
Interface Configuration Mode
ipv6 pim scope-border
<500-599>|<acl_name>
no ipv6 pim scope-border
To configure PIM-SM6 management boundary
for the interface and apply ACL for the
management boundary. With default settings,
ffx0::/13 is considered as the scope of the
management group. If ACL is configured, then
the scope specified by ACL permit command is
the scope of the management group. acl_name
should be standard IPv6 ACL name. The no
form of this command will remove the
configuration.