TP-Link Omada ER8411 VPN Router - Manual (Page 103)

User Guide 94
Configuring Transmission Routing Configurations
Mode Specify the policy routing mode for the rule.
Priority: In Priority Mode, the rule depends on the online detection result. If any WAN
port that you specify is online, the rule will take effect. If all the WAN ports that you
specify are offline, the rule will not take effect.
Only: In Only Mode, the rule always takes effect regardless of the WAN port status or
online detection result.
Description Enter a brief description for the rule.
Status Check the box to enable the rule.
6.3 Viewing the Routing Table
Choose the menu Transmission> Routing > Routing Table to load the following page.
Figure 6-3 Routing Table
The Routing Table shows the information of the current route entries.
Destination IP Displays the destination IP address the route leads to.
Subnet Mask Displays the subnet mask of the destination network.
Next Hop Displays the gateway IP address to which the packet should be sent next.
Interface Displays the physical network interface through which this route is accessible.
Metric Displays the metric to reach the destination IP address.