TP-Link Omada ER8411 VPN Router - Manual (Page 123)

User Guide 114
Configuring Firewall Firewall Configuration
list are configured, the router will apply the filter policy to the packets matching the MAC
address, and thus limit network traffic and manage network access behaviors.
Choose the menu
Firewall > MAC Filtering > MAC Filtering to load the following page.
Figure 2-9 MAC Filtering
Follow the steps below to configure MAC Filtering.
1) In the
General section, check the box to enable the MAC Filtering feature, configure the
conresponding parameters and click Save .
Allow packets with the
MAC addresses listed
below and deny the rest
Select to allow packets with the listed MAC address to pass through the
router, and packets with other MAC addresses will be dropped.
Deny packets with the
MAC addresses listed
below and allow the
rest
Select to drop packets with the listed MAC address, and the packets with
other MAC addresses will be allowed to pass through the router.
Direction Select All when you want to apply the policy to traffic both from LAN to
LAN and from LAN to WAN. Select LAN -> WAN when you want to apply
the policy only to traffic from LAN to WAN.
2) In the MAC Filtering List section, click Add to load the following page.
Figure 2-10 MAC Filtering
3) Specify the MAC name and address and click OK .
MAC Address Specify the MAC address of the device, and the MAC filtering policy will be
applied to traffic with the MAC address.