TP-Link Omada ER8411 VPN Router - Manual (Page 177)

User Guide 168
Configuring VPN Users Configuration
Network Mode Specify the network mode. There are two modes:
Client-to-LAN : Select this option when the L2TP/PPTP client is a single host. It’s
commonly used to access the internal service from outside.
LAN-to-LAN : Select this option when the L2TP/PPTP client is a VPN gateway. The
tunneling request is always initiated by a device. It’s commonly used for access
between two offices.
Max
Connections
Specify the maximum number of connections that the tunnel can support. Wihen
Client-to-LAN network mode is enabled, it can be used to limit the number of
devices connected at the same time.
Remote Subnet Specify a remote network. (This is the IP address range of the LAN on the remote
peer of the L2TP/PPTP tunnel.) It’s the combination of IP address and subnet mask.
It takes effect when LAN-to-LAN network mode is enabled.
Note:
• Create VPN connection accounts for remote devices to connect to the VPN server.
• If the router acts as the L2TP/PPTP client, you don’t need to configure the L2TP/ PPTP user
accounts on this page.