Configuring the nat-dmz, 4 configuring the nat-dmz – TP-Link Omada ER8411 VPN Router User Manual
Page 92
Configuring Transmission
NAT Configurations
User Guide 83
Trigger Protocol
Specify the protocol for the trigger port.
ALL:
Data packets are transmitted based on TCP or UDP protocols.
TCP:
Data packets are transmitted based on TCP protocol.
UDP:
Data packets are transmitted based on UDP protocol.
Incoming Port
Enter the incoming port or port range from which the data is received. Each entry
supports at most 5 groups of incoming ports. For example, you can enter 1-2 or
11-12. Note that the ports or port ranges cannot overlap with those of other port
triggering rules.
Incoming
Protocol
Specify the protocol for the incoming port.
ALL:
Data packets are transmitted based on TCP or UDP protocols.
TCP:
Data packets are transmitted based on TCP protocol.
UDP:
Data packets are transmitted based on UDP protocol.
Status
Check the box to enable the rule.
2) Click
OK
.
2.4 Configuring the NAT-DMZ
Choose the menu
Transmission > NAT > NAT-DMZ
and click
Add
to load the following
page.
Figure 2-4
Configuring the NAT-DMZ
Follow these steps to configure the NAT-DMZ
:
1) Specify the name of the NAT-DMZ rule and configure other related parameters.
Interface
Specify the effective interface for the rule.
Host IP Address
Specify the host IP address for NAT-DMZ.
Status
Check the box to enable the rule.