TP-Link Omada ER8411 VPN Router - Manual (Page 64)

Configuring Network USB Configuration
User Guide 55
9
USB Configuration
The USB Modem function is used to connect to the 3G/4G network of the ISP (Internet
Service Provider) as the WAN connection, after you connect the 3G/4G USB modem to the
USB port.
To configure the USB Modem, you should:
• Confirm that the USB modem is connected to the USB port properly.
• Specify the ISP information. You can specify the location and ISP, or you can set the
Dial Number, APN, Username and Password manually, which depends on the Config
Type you select.
9.1 Configuring USB Modem
■ Configuring the USB Modem automatically
Choose the menu Network > USB > USB Modem to load the following page.
Figure 9-1 Configuring the USB Modem automatically
In 3G/4G section, select the Config Type as Auto. Enter the corresponding parameters and
click Save .
USB Modem Displays the status of the 3G/4G USB modem.
Location Automatically selects and displays the region when the USB modem and SIM
card are successfully identified. If not, select the region from the drop-down
menu.