TP-Link Omada ER8411 VPN Router - Manual (Page 91)

User Guide 82
Configuring Transmission NAT Configurations
Internal Port Enter the service port or port range of the router for external network access. The
ports or port ranges cannot overlap with those of other virtual server rules.
Internal Server
IP
Enter the IP address of the specified internal server for the entry. All the requests
from the internet to the specified LAN port will be redirected to this host.
Protocol Specify the protocol used for the rule.
ALL: Data packets are transmitted based on TCP or UDP protocols.
TCP: Data packets are transmitted based on TCP protocol.
UDP: Data packets are transmitted based on UDP protocol.
Status Check the box to enable the rule.
2) Click OK .
2.3 Configuring the Port Triggering
Choose the menu Transmission > NAT > Port Triggering and click Add to load the
following page.
Figure 2-3 Configuring the Port Triggering
Follow these steps to configure the Port Triggering :
1) Specify the name of the Port Triggering rule and configure other related parameters.
Interface Specify the effective interface for the rule. If you choose multiple ports, the entry
will be applied to all selected ports simultaneously.
Trigger Port Enter the trigger port or port range from which the data flows out. Each entry
supports at most 5 groups of trigger ports. For example, you can enter 1 or
1-2. Note that the ports or port ranges cannot overlap with those of other port
triggering rules.