TP-Link Omada ER8411 VPN Router - Manual (Page 71)

User Guide 62
USB USB Modem Configuration
2
USB Modem Configuration
The USB Modem function is used to connect to the 3G/4G network of the ISP (Internet
Service Provider) as the WAN connection, after you connect the 3G/4G USB modem to the
USB port.
To configure the USB Modem, follow these steps:
1) Confirm that the USB modem is connected to the USB port properly.
2) Specify the ISP information. You can specify the location and ISP, or you can set the
Dial Number, APN, Username and Password manually.
3) Select the connection mode and configure the parameters according to the
requirements of your ISP.
4) Click Save.
2.1 Configuring USB Modem automatically
Choose the menu USB > USB Modem to load the following page.
Figure 2-1 Configuring the USB Modem automatically
In the 3G/4G section, select the Config Type as Auto. Enter the corresponding parameters
and click Save .
USB Modem Displays the status of the 3G/4G USB modem.