TP-Link Omada ER8411 VPN Router - Manual (Page 66)

Configuring Network USB Configuration
User Guide 57
Figure 9-2 Configuring the USB Modem manually
In 3G/4G section, select the Config Type as Manual. Enter the corresponding parameters
and click Save .
USB Modem Displays the status of the 3G/4G USB modem.
Dial Number, APN,
Username and
Password manually
If the ISP is not listed in the Mobile ISP list, please enter the Dial Number, APN
(Access Point Name), Username and Password that are provided by the ISP.
Connection Mode Select the connection mode and configure the parameters according to the
requirements of your ISP.
Connect Automatically: In this mode, the Internet connection reconnects
automatically anytime it gets disconnected.
Connect Manually: In this mode, you can click the Connect or Disconnect
button to control the Internet connection manually.
Upload Bandwidth Specify the upstream bandwidth of the USB Modem. This value is the upper limit
of the Maximum Upstream Bandwidth on Transmission > Bandwidth Control
page. Also, this value determines the bandwidth ratio of USB Modem and WAN
ports after Bandwidth Based Balance Routing is enabled on Transmission >
Load Balancing > Basic Settings page.
Download Bandwidth Specify the downstream bandwidth of the USB Modem. This value is the upper
limit of the Maximum Downstream Bandwidth on Transmission > Bandwidth
Control page. Also, this value determines the bandwidth ratio of USB Modem and
WAN ports after Bandwidth Based Balance Routing is enabled on Transmission
> Load Balancing > Basic Settings page.