TP-Link Omada ER8411 VPN Router - Manual (Page 95)

User Guide 86
Configuring Transmission Bandwidth Control Configuration
Figure 3-2 Add Bandwidth Control rules
Specify the name of the Bandwidth Control rule and configure other related parameters.
Then click
OK .
Direction Specify the data stream direction for the rule.
Group Select the IP groups you have created from the drop-down list. With IPGROUP_
ANY selected, the rule will apply to all clients. If no desired IP groups have been
created, go to Preferences > IP Group page to create one.
Maximum
Upstream
Bandwidth
Specify the limit of upstream bandwidth for the specific user to transmit traffic to
the internet through the router.
Maximum
Downstream
Bandwidth
Specify the limit of downstream bandwidth for the specific user to receive traffic
from the internet through the router.
Mode Select the bandwidth control mode for the controller users.
Shared: The total bandwidth for all users is equal to the specified values in
upstream and downstream bandwidth.
Individual: The bandwidth for each user is equal to the specified value in
upstream and downstream bandwidth.
Effective Time Specify the time for the rule to take effect. Any means it always takes effect. If
no desired time ranges have been configured, go to Preferences > Time Range
page to create one.
Description Enter a brief description for the rule.
ID Assign a number to the rule to reorder the list.
Status Check the box to enable the rule.