TP-Link Omada ER8411 VPN Router - Manual (Page 45)

User Guide 36
Configuring Network Switch Configuration
Follow these steps to configure Port Mirror:
1) In
Settings section, enable Port Mirror function, and choose the mirror mode.
Enable Port
Mirror
Check the box to enable Port Mirror function.
Mirror Mode Choose the mirror mode which includes Ingress , Egress and Ingress and Egress .
Ingress: The packets received by the mirrored port will be copied to the mirroring
port.
Egress: The packets sent by the mirrored port will be copied to the mirroring port.
Ingress and Egress: Both the incoming and outgoing packets through the
mirrored port will be copied to the mirroring port.
2) In the Monitor List section, set the mirroring port and the mirrored port(s), then click
Save .
Mirroring Port The packets through the mirrored port will be copied to this port. Usually, the
mirroring port is connected to a data diagnose device, which is used to analyze
the mirrored packets for monitoring and troubleshooting the network.
Mirrored Port The packets through this port will be copied to the mirroring port. Usually, the
mirrored ports are the ports to be monitored.
6.3 Configuring Rate Control
Rate Control enables you to set limit to the traffic rate for the specific packets on each port
to manage the traffic flow of your network.
Choose the menu
Network > Switch > Rate Control to load the following page.
Figure 6-3 Configuring Rate Control