TP-Link Omada ER8411 VPN Router - Manual (Page 25)

User Guide 16
Configuring Network WAN Configuration
Primary/
Secondary DNS
(Optional) Enter the IP address of the DNS server provided by your ISP.
VLAN Add the WAN port to a VLAN. Generally, Generally, you don’t need to enable VLAN
for the WAN port unless required by your ISP.
VLAN ID If VLAN for the WAN port is enabled, you need to enter a VLAN ID. Then the WAN
port is automatically assigned to the VLAN. By default, the egress rule of the VLAN
is UNTAG, so the packets are transmitted by the WAN port without VLAN tags. If
you want the WAN port to transmit packets with VLAN tag, you need to configure its
egress rule as TAG. To configure VLANs, go to Network > VLAN > VLAN .
Negotiation
Mode
Select the negotiation mode for the port. You can set the mode as Auto, or manually
set the speed and duplex mode for the port. It is recommended to configure both
devices of a link to work in Auto-Negotiation mode or manually configure them to
work in the same speed and duplex mode.
If the two devices at both sides work in Auto mode, they will advertise their speed
and duplex abilities to each other, and negotiate the optimal speed and duplex mode.
If the local device works in Auto mode while the peer device does not, the local
device will automatically detect and match the speed with the peer device. The local
device will work in half-duplex mode, no matter what duplex mode the peer device is
in.
Flow Control Click the button to active/terminate the connection.
■ Configuring the PPPoE
Choose the menu Network > WAN > SFP+ WAN1 to load the following page.
Figure 2-4 Configuring the PPPoE