TP-Link Omada ER8411 VPN Router User Manual
Page 27
User Guide 18
Configuring Network
WAN Configuration
Negotiation
Mode
Select the negotiation mode for the port. You can set the mode as Auto, or manually
set the speed and duplex mode for the port. It is recommended to configure both
devices of a link to work in Auto-Negotiation mode or manually configure them to
work in the same speed and duplex mode.
If the two devices at both sides work in Auto mode, they will advertise their speed
and duplex abilities to each other, and negotiate the optimal speed and duplex mode.
If the local device works in Auto mode while the peer device does not, the local
device will automatically detect and match the speed with the peer device. The local
device will work in half-duplex mode, no matter what duplex mode the peer device is
in.
Flow Control
Click the button to active/terminate the connection.
Secondary
Connection
Secondary connection is required by some ISPs. Select the connection type required
by your ISP.
None:
Select this if the secondary connection is not required by your ISP.
Dynamic IP:
Select this if your ISP automatically assigns the IP address and subnet
mask for the secondary connection.
Static IP:
Select this if your ISP provides you with a fixed IP address and subnet mask
for the secondary connection.
Connect/
Disconnect
Click the button to active/terminate the connection.