TP-Link Omada ER8411 VPN Router - Manual (Page 105)

User Guide 96
Configuring Transmission Configuration Examples
valid public IP address. Note that One-to-One NAT take effects only when the connection
type of WAN port is Static IP.
7.1.4 Configuration Procedure
Follow the steps below to configure NAT on the router:
■ Configuring the static routing
1) Choose the menu Transmission > Routing > Static Route to load the configuration
page, and click Add .
2) Add static routes for the two departments respectively: Specify the entry name as RD/
Market, enter 172.16.10.0/172.16.20.0 as the destination IP, and specify the VLAN 1
interface IP of L3 switch as next hop, then choose the interface as WAN1. Keep Status
of this entry as Enable . Click OK .
Figure 7-2 Configuring the Static Routing for RD Department
Figure 7-3 Configuring the Static Routing for Market Department
■ Configuring the One-to-One NAT
1) Choose the menu Transmission > NAT > One-to-One NAT to load the configuration
page, and click Add .