TP-Link Omada ER8411 VPN Router - Manual (Page 107)

User Guide 98
Configuring Transmission Configuration Examples
7.2.2 Network Topology
Figure 7-5 Network Topology
Internet Internet
WAN1
PPPoE 8Mbps
WAN2
Dynamic IP 12Mbps
Gateway
PC
7.2.3 Configuration Scheme
To meet the requirement, configure WAN parameters on the router in order that the
two WAN links can work properly and have access to the internet, then configure load
balancing on the router to aggregate two WAN links.
7.2.4 Configuration Procedure
Follow the steps below to configure load balancing on the router:
■ Configuring the WAN parameters
For WAN1 port, configure the connection type as PPPoE, and specify Upstream and
Downstream bandwidth for this link based on your ADSL bandwidth (You could consult
your internet Service Provider for the bandwidth information).
For WAN2 port, configure the connection type as Dynamic IP, and specify Upstream
and Downstream bandwidth for this link according to data that ISP provides.
Make sure two WAN links can work properly and have access to the internet.
■ Configuring the Load Balancing
Choose the menu Transmission> Load Balancing > Basic Settings to load the
configuration page. Enable Load Balancing globally, and click Save . Enable Application
Optimized Routing, and enable Bandwidth Based Balancing Routing on WAN1 port and
WAN2 port. Click Save .