McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 - Manual (Page 115)

6
Configuring an F_Port Extension over an Ethernet WAN 6-9
Configuring a 2x2 Ethernet Wide Area Network
NOTE: If you are using the Configuration IP Address Worksheet from Appendix
J, enter the following information:
For Node10, enter the IP address labeled and the gateway address labeled
.
For Node20, enter the IP address labeled and the gateway address labeled
.
NOTE: The Serial Number is located on the front of the chassis and is used to
identify the UltraNet Edge 3000.
4. Click Apply to enable the maintenance interface. UltraNet
ConfigManager will load the IP address information into the
UltraNet Edge 3000 and will reboot.
NOTE: Watch the UltraNet Edge Configuration Status box for allocated and
assigned messages. These messages will only appear for a brief moment and
will indicate if the unit is resetting and booting up.
When finished booting up, the letters PMA will display and
remain in the Alphanumeric messages window (see Figure 2-4 in
Chapter 2) until the network configuration is delivered. Delivery
is performed after the configuration in UltraNet ConfigManager
is completed.
IP Address of PC running UCM