McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 User Manual
Page 198
8
8-26
McDATA UltraNet Edge 3000 User Guide
Configuring a 1x1 Ethernet Wide Area Network
•
USD-X Nodes with FICON I/Fs - Check this box if you wish to
change the PPC adapter parameters for FICON interfaces in
USD-X nodes. This check box is disabled if there are no USD-X
nodes on the Network Map.
•
Edge Nodes with FICON I/Fs - Check this box if you wish to
change the node parameters for Edge nodes with FICON
interfaces. This check box is disabled if there are no Edge nodes
on the Network Map.
•
Next - Click Next to proceed to the next dialog.
•
Back - Click Back to return to the previous dialog.
•
Cancel - Click Cancel to exit the FICON Global Settings Wizard.
•
Help - Click Help, or press F1, to view the help information for
this dialog.
Select FICON Tape
Write Pipelining I/Fs
This dialog displays all FICON interfaces that support Tape Write
Pipelining in the network. Additionally, this dialog displays the
current Tape Write Pipelining configuration information for the
FICON interface. Use this dialog to select interfaces that you want to
configure.
•
Select All - Click Select All to select all FICON Tape Write
Pipelining interfaces.
•
Deselect All - Click Deselect All to deselect all checked FICON
Tape Write Pipelining interfaces.
•
Back - Click Back to return to the previous dialog.
•
Next - Click Next to proceed to the next dialog.
•
Cancel - Click Cancel to exit the FICON Global Settings Wizard.
•
Help - Click Help, or press F1, to see information about this
dialog.
Configure FICON Tape
Write Pipelining
Parameters
Use this dialog to select and enter the Tape Write Pipelining values
for the selected FICON interfaces.
•
Set - Check the Set box to enter a value for the parameter
displayed to the right. The value in the corresponding field is
only used if the Set box is checked.