McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 User Manual
Page 121
6
Configuring an F_Port Extension over an Ethernet WAN
6-15
Configuring a 2x2 Ethernet Wide Area Network
NOTE:
Use I/O port 3 for all 1x1 configurations. When configuring a 2x2, use
I/O port 3 to connect the first circuit and I/O port 4 for the second circuit.
The IP Circuit Wizard Node10 Configure Interface dialog box
appears.
This dialog box enables you to configure the IP WAN interface
properties for Node10.
7. Enter the IP Address (IP WAN address) and the Subnet Mask.
The IP WAN address must be different from the Ethernet
maintenance interface address.
NOTE:
If you are using the Configuration IP Address Worksheet from Appendix
J, enter the following information:
For Node10, enter the IP address labeled
for the circuit on a 1x1 or 2x1
configuration or the 1st circuit of a 2x2 or 1x2.
For the 2nd circuit of a 2x2 or 1x2 configuration, enter the IP address labeled
.
8. Click Next>.
The IP Circuit Wizard Node10 Configure Gateway dialog box
appears.
The gateway IP address entered in this dialog box will be the
router IP WAN address attached to the UltraNet Edge 3000
(Node10).