McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 - Manual (Page 291)

12
Hardware Maintenance 12-13
Gigabit Ethernet Interface Card Removal Procedure
2. Secure the 10/100 Ethernet interface card using the two screws
that were made available during the removal procedure. Torque
to 6 in-lbs
.
3. Reconnect the power cords (rear).
4. Turn on the power supplies.
5. Replace the cover by following the Top Cover Installation
Procedure.
Gigabit Ethernet Interface Card Removal Procedure
Use the following procedure to remove the Gigabit Ethernet (Gig-E)
interface card from the UltraNet Edge 3000.
Tools required: A small Phillips screwdriver and an adjustable
Torque driver, rated between 3 and 15 in-lbs.
CAUTION
Attach a wrist strap and follow ESD procedures (see page B-19)
during the handling of all electronic components.
1. Follow the Top Cover Removal Procedure.
2. Turn off both power supplies on the UltraNet Edge 3000.
3. Unplug the power cords.
4. Locate the Gig-E interface card.
The Gig-E interface card is located on the front left side of the
UltraNet Edge 3000 and can occupy I/O 3 and I/O 4 (see
illustration below).
5. Remove the two screws at the rear of the Gig-E interface card.
6. Carefully pull the Gig-E interface card up. The Gig-E interface
card is connected to two socketed connectors.
7. Remove the Gig-E interface card from the chassis.