McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 - Manual (Page 124)

6
6-18 McDATA UltraNet Edge 3000 User Guide
Configuring a 2x2 Ethernet Wide Area Network
13. Enter the IP Address (IP WAN address) and the Subnet Mask.
The IP WAN address must be different from the Ethernet
maintenance interface address.
NOTE: If you are using the Configuration IP Address Worksheet from Appendix
J, enter the following information:
For Node20, enter the IP address labeled for the circuit on a 1x1 or 2x1
configuration or the 1st circuit of a 2x2 or 1x2.
For the 2nd circuit of a 2x2 or 1x2 configuration, enter the IP address labeled
.
14. Click Next>.
The IP Circuit Wizard Node20 Configure Gateway dialog box
appears.
The gateway IP address entered in this dialog box will be the
router IP address attached to the UltraNet Edge 3000 (Node20).
At this time you can configure the gateway address (the router IP
address attached to the UltraNet Edge 3000) to create a static
route to the destination IP address (Node10 in this example) by
continuing through the remainder of the steps in this procedure.