McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 - Manual (Page 90)

5
5-14 McDATA UltraNet Edge 3000 User Guide
Configuring a 1x1 Ethernet Wide Area Network
The IP WAN address must be different from the Ethernet
maintenance interface address.
NOTE: If you are using the Configuration IP Address Worksheet, enter the
following information:
For Node10, enter the IP address labeled
for the circuit on a 1x1 or 2x1
configuration or the 1st circuit of a 1x2 or 2x2.
For the 2nd circuit of a 1x2 or 2x2 configuration, enter the IP address labeled
.
8. Click Next>.
The IP Circuit Wizard Node10 Configure Gateway dialog box
appears.
The gateway IP address entered in this dialog box will be the
router IP WAN address attached to the UltraNet Edge 3000
(Node10).
At this time you can configure the gateway address (the router IP
WAN address attached to the UltraNet Edge 3000) to create a
static route to the destination IP address (Node20 in this example)
by continuing through the remainder of the steps in this
procedure.
NOTE: If you do not know what the router IP address attached to the
UltraNet Edge 3000 is at this point, you can add the static route at a later
time. To add static routes at a later time, see Appendix E, Static Routes.