McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 - Manual (Page 78)

5
5-2 McDATA UltraNet Edge 3000 User Guide
Configuring a 1x1 Ethernet Wide Area Network
6. Adding an IP Circuit
7. Creating a Data Path
8. Delivering the Configured Network
NOTE: For help on the configuration process, click the Help button on the
active dialog box or press the F1 key.
Gathering the IP
Addresses Before starting the configuration procedure in ConfigManager you
will need to gather the IP addresses for your network. The IP host
addresses and the completed UltraNet Edge Storage Router
Configuration IP Address Worksheet in Appendix J will be used as
examples in the configuration process.
Figure 5-1 shows an example of a network configured with two
UltraNet Edge 3000s as a 2x2 implementation.
Figure 5-1 Sample E_port Ethernet WAN with two UltraNet Edge 3000s
Using the Configuration IP Address Worksheet in Appendix J, gather the
IP addresses and associated subnet masks to configure each UltraNet
Edge 3000.
You will need the following addresses:
• UltraNet Edge 3000 Ethernet Maintenance Interface IP host
address
Default
Gateway 1
Router/
Switch
192.168.10.3
192.168.10.1
192.168.100.1
192.168.100.4
192.168.20.3
192.168.20.1
192.168.200.1
192.168.200.4
IP Cloud
Fibre
Channel
Switch
UltraNet Edge
Storage Router
Node 10 UltraNet Edge
Storage Router
Node 20
Default
Gateway 2
Router/
Switch Sb03
9
Maintenance IP
Ethernet WAN Ethernet WAN
Maintenance IP
Fibre
Channel
Switch
Router/
Switch
192.168.101.4 192.168.201.4
IP Cloud
Router/
Switch
Fibre
Channel
Switch
Fibre
Channel
Switch