McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 - Manual (Page 378)

D-6 UltraNet™ Edge Storage Router 3000 User Guide
Time Synchronization Protocol
ConfigManager ensures that Disk Streaming is also enabled on the
peer interface(s).
The Enable Disk Streaming check box is displayed only if the Edge
node has a chassis software version of 3.1.2 or greater.
OK
Click OK to exit this dialog box and to save changes.
Cancel
Click Cancel to exit this dialog box without saving any changes.
Network
Click Network to select the network routing type.
Help
Click Help to view the Help for this dialog box.
Time Synchronization Protocol
The UltraNet Edge 3000 TAI (Temps Atomique International) driver
is responsible for time synchronization using the TAI time format.
The TAI driver is configured automatically through UCM to support
the TAI protocol. It can also be manually configured as a Network
Time Protocol (NTP) client or shut off completely.
SNTP IPv4 is supported on the UltraNet Edge 3000 via the TAI driver
and is compatible with the NTP protocol.
Refer to the UltraNet Edge Storage Router Command Reference
(620-000253-313) for the TAI commands.
Configure the Time
Synchronization
Protocol The Time Synchronization Protocol default in UCM is set to the TAI
Server option. If you would like to configure it as an NTP client or
shut it off completely, refer to the following procedures.